SM150T User Manual 1.0
Operation
13
HH2 Meter
This assumes you have version 2.8 or later for both the PC
software HH2Read and the HH2 firmware (see foot of page).
Connect the SM150T to the HH2 meter.
Press
Esc
to turn the meter on, and if necessary press
again until the HH2 displays the start-up screen.
Set the meter to read from an SM150T:
►
Press
Set
and scroll down to the
Device
option.
►
Press
Set
again and scroll down to select
SM150T.
►
Press
Set
to confirm this choice.
Make sure the HH2 is correctly configured for your soil type:
►
At the start-up screen, press
Set
and scroll down to the
Soil Type
option.
►
Press
Set
again and scroll down to the
appropriate soil type (use
Mineral
for sand,
silt or clay soils or
Organic
for peaty soils)
►
Press
Set
to confirm this choice.
Choose the units in which you want to display the readings.
►
At the start-up screen, press
Set
and scroll down to the
Display
option.
►
Press
Set
again and scroll down to select units.
►
Press
Set
to confirm this choice.
Press
Read
to take a reading.
Press
Store
to save or
Esc
to discard the reading.
Remove the SM150T from the soil and move to a new location...
If you have saved data, connect your HH2 to a PC and run
HH2Read
to retrieve the readings.
For an upgrade contact Delta-T.
See also:
HH2 User Manual v4.2
or later
Note: The HH2 does not read temperature
Device:
SM150T
Soil Type:
Mineral
SM150T Store?
20.3 %vol
