31
Using Tandem Trigno Systems
Two Trigno systems may be used in tandem, connected to the
same computer as a synchronized 32 sensor, 128 channel system.
Initial Connectivity
To use two Trigno systems in a tandem configuration, connect the
USB cable from each base station to the same computer. If using
EMGworks, also connect the Trigger Cross-Over Cable (DC-C02)
between the trigger ports on the two base stations. After connect-
ing the USB cables and powering each base station, launch either
the Trigno Control Utility application or EMGworks. Note that
the trigger cross-over cable will work irrespective of orientation.
Figure 25. Installation of the Trigger Cross-Over cable to synchronize two base
stations when used with EMGworks.
Communication Frequencies
When the software detects the presence of two bases connected to
the computer, the frequency sets on each base are automatically
changed to allow the simultaneous communication of 32 sensors.
The user is required to re-pair each sensor to use these new
communication frequencies. Similarly, when reverting to the use of
a single base, the communication frequency set will be restored to
the option selected by the user (Set A, B, C, or D) and the sensors
must again be re-paired.
Synchronization
All channels of data collected in a tandem configuration are fully
synchronized between the two bases.
Summary of Contents for Tringo
Page 2: ......
