13
Getting Started with the Trigno
TM
System
Software Installation
The Trigno EMG system is controlled by a PC through the USB
port, and thus requires specialized software. Trigno Systems
include a Delsys Software DVD containing EMGworks Signal
Acquisition and Analysis Software and the Trigno Control Utility
software for use with 3rd party data acquisition systems.
Install EMGworks from the Delsys Software DVD prior to
connecting the Trigno Base Station to the computer.
Powering the Base Station
Connect the Trigno power supply to the circular DC jack located
on the side of the Base Station. Energize the power supply by con-
necting it to a Mains outlet or to an isolation transformer. Ensure
that the PC to be used with the Base Station is connected to the
same isolation transformer. Please refer to Appendix I for clarifica-
tion on using an Isolation Transformer. The power LED on the
Base Station will illuminate anytime power is applied. Ensure that
the Base Station antenna is securely attached to the antenna con-
nector.
Figure 4. Connecting the Trigno Base Station power supply.
Connecting the Base Station
It is important to install EMGworks software prior to connecting
the Base Station to the PC. If not, the “Found New Hardware”
dialog will appear and Windows will prompt for a driver location.
Cancel this dialog and install EMGworks from the Delsys DVD in
order to register the Trigno drivers with the operating system.
Summary of Contents for Tringo
Page 2: ......
