9
B9.
P button: to access the Programming
menu.
B10.
button: turns the appliance on and
off.
Explanation of lights
indicates the need to descale the
appliance.
The Steam function is selected.
The hot Water function is selected.
indicates the button to press to exit the
menu or cancel the selected function.
The auto-Start function is active.
an alarm is displayed (see “explanation of
lights”).
indicates the button to press to exit the
menu or cancel the selected function.
PRElIMINARY CHECkS
Checking the appliance
after removing the packaging, make sure
the product is complete and undamaged and
that all accessories are present. do not use
the appliance if it is visibly damaged. Contact
de’longhi Customer Services.
Installing the appliance
Important!
When installing the appliance, respect the
following safety warnings:
• The appliance gives off heat. After positioning
the appliance on the worktop, leave a space
of at least 3 cm between the surfaces of the
appliance and the side and rear walls and at
least 15 cm above the coffee maker.
• Water penetrating the coffee maker could
cause damage. do not place the appliance
near taps or sinks.
• The appliance could be damaged if the water
it contains freezes.
do not install the appliance in a room where
the temperature could drop below freezing
point.
• Arrange the power cable in such a way that
it cannot be damaged by sharp edges or
contact with hot surfaces (e.g. electric hot
plates).
Connecting the appliance
Important!
Check that the mains power supply voltage
corresponds to the value indicated on the rating
plate on the bottom of the appliance.
Connect the appliance to an efficiently earthed
and correctly installed socket with a minimum
current rating of 10a only.
if the power socket does not match the plug on
the appliance, have the socket replaced with a
suitable type by a qualified professional.
Using the coffee maker for the first time
Please note :
•
Coffee has been used to factory test the
appliance and it is therefore completely
normal for there to be traces of coffee in the
mill.
The machine is, however, guaranteed to be
new.
•
you should customise water hardness as
soon as possible following the instructions
in the section “Setting water hardness” on
page
18.
1.
Plug the appliance into the mains socket
and place the main switch on the back of the
appliance in the i position (fig. 1).
you must first choose the language (the
languages scroll through at intervals of about 2
seconds).
2.
When english appears, press and hold
the
button
for a few seconds
(fig.
2).
once the language has been saved, the
message “english installed” is displayed.
Follow the instructions indicated by the
appliance:
3.
“Fill TanK!”: remove the water tank, fill to
the MaX line with fresh water then replace in
the appliance (fig. 3).
4. Turn the cappuccino maker outwards and
place a container underneath (fig. 4) with a
minimum capacity of 100 ml.
5. “hot water... confirm?”: press the
button to confirm.(fig. 2). “Please Wait...” is
displayed and the appliance begins to deliver
hot water.
