15
Important! Danger of burns
Stop steam delivery before removing the
container with the frothed milk to avoid burns
caused by splashes of boiling milk.
10. add the frothed milk to the cup of coffee
prepared previously.
The cappuccino is ready. Sweeten to taste
and, if desired, sprinkle the froth with a little
cocoa powder.
Making hot milk (without froth)
To make hot milk without froth, proceed as de-
scribed in the above section, making sure the
ring on the cappuccino maker is positioned up-
wards in the “laTTe” position.
Cleaning the cappuccino maker after use.
Clean the cappuccino maker each time you use it
to avoid the build-up of milk residues or blocka-
ges.
Important! Danger of burns
When cleaning the cappuccino maker, a little hot
water comes out. avoid contact with splashes of
water.
1. discharge a little water for a few seconds by
pushing the
button. Then push the same
button to stop the flow of hot water.
2. Wait a few minute for the cappuccino
maker to cool down. Turn the cappuccino
maker outwards and remove it by pulling it
downwards (fig. 18).
3. remove the ring upwards (fig. 19).
4. Wash all parts of the cappuccino maker
thoroughly with warm water.
5. Make sure the two holes shown by the arrow
in fig. 20 are not blocked. if necessary, clean
with a pin.
6. replace the inner section by inserting it
carefully onto the adjustable tube, then insert
the steam nozzle and turn anticlockwise to
lock it in place.
HEATING WATER
Preparation
Important! Danger of burns.
never leave the machine unsupervised while
delivering hot water. Stop delivery of hot water
as described below when the cup is full. The hot
water spout becomes hot while water is being
delivered and must be held by the handle only.
1. Place a container under the spout (as close
as possible to avoid splashes) (fig. 4).
2. Press the
button until the
light
comes on.
3. Press the
button (fig. 1); “hot water” is
displayed;
4.
Water flows out of the spout. delivery stops
automatically after 250ml.
6.
To interrupt delivery of hot water manually,
press the
button again.
Please note!
•
if energy saving has been enabled, delivery
could be delayed a few seconds.
• You should not deliver hot water for more
than 3 minutes at a time.
Changing the quantity
The appliance is set by default to automatically
deliver 250ml of hot water. To modify these
quantities, proceed as follows:
1.
Position a container under the spouts.
2. Press the
button until the
light
comes on.
3. Press and hold the
button down for at
least 8 seconds (fig. 1); the message “hot
Water Programme Quantity” is displayed;
3. When the hot water in the cup reaches the
required level, press the
button again.
The machine is now reprogrammed with the new
quantity.
