Replacing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer
. After working inside your
computer, follow the instructions in
After working inside your
computer
. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1
Slide the palm-rest assembly under the display hinges and align the screw
holes on the palm-rest assembly with the screw holes on the display
hinges.
2
Replace the screws that secure the palm-rest assembly to the display
hinges.
3
Close the palm-rest assembly.
4
Route the display cable through the routing guides on the fan.
5
Align the screw hole on the display cable with the screw hole on the I/O
board.
6
Replace the screw that secures the display cable to the I/O board.
7
Connect the media-card reader cable to the I/O board.
8
Adhere the tapes that secure the display cable to the fan and the I/O
board.
9
Connect the display cable to the system board.
10
Align the screw holes on the display-cable bracket with the screw holes
on the system board.
11
Replace the screws that secure the display-cable bracket to system
board.
12
Adhere the tape over the display-cable bracket.
13
Connect the wireless-card cables to the wireless card.
14
Align the screw hole on the wireless-card bracket with the screw hole on
the system board.
15
Replace the screw that secures the wireless-card bracket to the system
board.
16
Adhere the tape that secures the antenna cables to the system board.
60
