2.
Remove the hard drive (see
Removing the Hard Drive
).
3.
Remove the WLAN card (see
Removing a WLAN Card
).
4.
Remove the hinge cover (see
Removing the Hinge Cover
).
5.
Remove the keyboard (see
Removing the Keyboard
).
6.
Remove the display assembly (see
Removing the Display Assembly
).
7.
Remove the four rubber display-bumpers and two mylar screw-covers from the display bezel.
8.
Remove the six M2.5 x 5-mm shoulder screws from the display bezel.
9.
Starting at the middle bottom of the display panel, use your fingers to separate the bezel from the top cover, then lift the inside edges to separate the
remainder of the bezel.
Replacing the Display Bezel
1.
Starting at any corner, use your fingers to gently snap the bezel into place to secure it to the top cover.
2.
Replace the six M2.5 x 5-mm shoulder screws in the display bezel.
3.
Replace the four rubber display bumpers and two mylar screw covers in the display bezel.
4.
Replace the display assembly (see
Replacing the Display Assembly
).
5.
Replace the keyboard (see
Replacing the Keyboard
).
6.
Replace the hinge cover (see
Replacing the Hinge Cover
).
7.
Replace the WLAN card (see
Replacing a WLAN Card
).
8.
Replace the hard drive (see
Replacing the Hard Drive
).
1 mylar screw covers (2)
2 rubber display bumpers (4)
3 M2.5 x 5-mm screws (6) 4 display bezel
NOTICE:
Removal of the bezel from the top cover requires extreme care to avoid damage to the bezel.
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTE:
This procedure assumes that you have completed the removal procedure first.
Summary of Contents for Vostro 1310
Page 24: ......
