Dell PowerVault NX300, Hardware Owner'S Manual

Page: 65 / 192

Using the System Setup Program and UEFI Boot Manager
65
PCI IRQ Assignments Screen
Serial Communication Screen
Option Description
<PCIe device> Use the <+> and <-> keys to manually select an IRQ
for a given device, or select
Default to allow the BIOS to
select an IRQ value at system startup.
Option Description
Serial Communication
(
On without Console
Redirection default)
Selects whether the serial communication devices
(
Serial Device 1 and Serial Device 2 ) are enabled in
BIOS. BIOS console redirection can also be enabled and
the port address used can be specified.
Options are On without Console Redirection , On with
Console Redirection via COM1 , On with Console
Redirection via COM 2, and Off .
Serial Port Address
(
Serial Device 1=COM1,
Serial Device2=COM2
default)
Sets the serial port addresses for the two serial devices.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL, configure
the same port address for console redirection and the
serial device.
External Serial Connector
( Serial Device1 default)
Specifies whether Serial Device 1 , Serial Device 2 , or
Remote Access Device has access to the external serial
connector.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL, configure
the same port address for console redirection and the
serial device.
Failsafe Baud Rate
(
115200 default)
Displays the failsafe baud rate used for console
redirection. BIOS attempts to determine the baud rate
automatically. This failsafe baud rate is used only if the
attempt fails. This rate should not be adjusted.
Remote Terminal Type
(
VT100/VT220 default)
Sets the remote console terminal type, either
VT100 / VT220 or ANSI .
Redirection After Boot
(
Enabled default)
Enables or disables BIOS console redirection when the
operating system is loaded.
book.book Page 65 Thursday, August 13, 2009 7:27 AM