Figure 74. Applying thermal grease on the top of the processor
1
processor
2
thermal grease
3
thermal grease syringe
3
Place the heat sink onto the processor.
4
Tighten one of the four screws to secure the heat sink to the system board.
5
Tighten the screw diagonally opposite to the first screw you have tightened.
NOTE:
Do not over-tighten the heat sink retention screws when installing the heat sink. To prevent over-tightening, tighten
the retention screw until resistance is felt, and stop after the screw is seated. The screw tension should not be more than 6
in-lb (6.9 kg-cm).
6
Repeat the procedure for the remaining two screws.
Installing and removing system components
139
