Removing the optional internal dual SD module
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your system section.
3
If installed, remove the SD cards.
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
1
Locate the internal dual SD module (IDSDM) on the system board. To locate the internal dual SD module connector, see the System
board connectors section.
2
Holding the pull tab, lift the IDSDM out of the system.
Figure 52. Removing the internal dual SD module (IDSDM)
1
IDSDM
2
pull tab
3
IDSDM connector
Next steps
1
Install the IDSDM.
2
If removed, install the SD cards.
3
Follow the procedure listed in the After working inside your system section.
Installing and removing system components
113
