Codes and Messages
3-7
(PEHGGHG
VHUYHU
PDQDJHPHQW
HUURU
(PEHGGHG
VHUYHU
PDQDJHPHQWLV
QRWSUHVHQW
Embedded server
management
memory may be
temporarily
corrupted
Shut down the system to
clear the memory, and
then restart the system.
If the problem persists,
disconnect all power
cables from the system
for at least one minute;
then try again.
*DWH$
IDLOXUH
Faulty keyboard
controller (defective
system board)
Replace the system
board.
*HQHUDO
IDLOXUH
Corrupted or
improperly installed
operating system
Reinstall the operating
system.
+DUGGLVN
GULYHUHDG
IDLOXUH
+DUGGLVN
IDLOXUH
Incorrect configura-
tion settings in
System Setup pro-
gram, improperly
connected hard-disk
drive, faulty hard-
disk drive controller
subsystem (defec-
tive system board),
or loose power
cable
Check the primary and
secondary SCSI
configuration settings in
the System Setup
program. Reinstall the
hard-disk drive. Check
the interface cable and
power cable connections
to the backplane board.
If
the problem still persists,
replace the system
board.
,QYDOLG
FRQILJXUDWLRQ
LQIRUPDWLRQ
SOHDVHUXQ
6(783SURJUDP
Incorrect ISA_CLR
jumper configura-
tion, incorrect
configuration set-
tings in System
Setup program, or
faulty battery
Remove the plug from
the ISA_CLR jumper.
Check the System Setup
configuration settings.
Replace the battery.
,QYDOLG&38
VSHHG
GHWHFWHG
FKHFNMXPSHUV
Incorrect micro-
processor jumper
configuration
Check the microproces-
sor speed jumper.
,QYDOLG195$0
FRQILJXUD
WLRQ
UHVRXUFH
UHDOORFDWHG
Resource conflict
detected and
corrected when sys-
tem resources were
allocated using the
RCU
No action is required.
7DEOH6\VWHP0HVVDJHV
FRQWLQXHG
0HVVDJH
&DXVH
&RUUHFWLYH$FWLRQ
