4-32
Dell PowerEdge 4300 Systems Service Manual
2. Remove the two retention pins from the SEC cartridge and heat sink
assembly (see Figure 4-28).
)LJXUH6(&&DUWUHDW6LQN5HPRYDO
3. Pull the SEC cartridge straight up out of the connector and guide bracket
assembly (some force may be required).
To replace an SEC cartridge, make sure the cartridge release latches are in the
open position, orient the new SEC cartridge in the guide bracket assembly (as
shown in Figure 4-28) and seat it firmly, and then snap the release latches back
into place. Reinstall the two retention pins.
To install an SEC cartridge where there was none before, you will need to
remove the installed terminator card (see the next subsection, “Terminator
Card”).
NOTE: Do
not
attempt to operate the system with the microprocessor set to a
speed other than the specified rating.
SEC cartridge
release latches (2)
heat sink
SEC cartridge
retention pins (2)
guide bracket
assembly
