I n s t a l l i n g o r R e p l a c i n g a n E R A / O C a r d
1-5
7
Install the ERA/O card in the system:
a
Unpack the ERA/O card.
If you are replacing an ERA/O card, see "Removing an ERA/O Card" for removal
instructions before continuing with the next step.
b
Position the ERA/O card so that the card connector is directly over the connector
on the system board and the mounting holes in the card line up with the support
posts on the system board. See Figure 1-4.
c
Press down until the ERA/O card connector is fully seated in the connector on the
system board and the support posts are secured in the mounting holes on the card.
F i g u r e 1 - 4 .
I n s t a l l i n g t h e E R A / O C a r d
ERA/O card
connector
ERA/O card
system board
support posts (4)
mounting
holes (4)
5U106ebk3.book Page 5 Tuesday, April 15, 2003 1:22 PM
