1-6
I n s t a l l i n g o r R e p l a c i n g a n E R A / O C a r d
www
.dell.com | support.dell.com
8
Reinstall the expansion-card guide:
a
Holding the expansion-card guide at a 45-degree angle, insert the two tabs at the
ends of the expansion-card guide base into the slots on the system board. See
Figure 1-5.
b
Rotate the expansion-card guide down until the clip snaps securely onto the
system board.
F i g u r e 1 - 5 .
R e i n s t a l l i n g t h e E x p a n s i o n - C a r d G u i d e
9
Reinstall expansion cards that you removed:
a
Position the expansion card so that the card-edge connector aligns with the
expansion-card connector on the system board. See Figure 1-2.
b
Insert the card-edge connector firmly into the expansion-card connector until the
card is fully seated.
c
When the card is seated in the connector, close the expansion-card latch.
NOTE:
SCSI cables connected from an expansion card to the SCSI backplane
board should be routed under the front fan assembly.
d
Reconnect all expansion-card cables.
s
lo
ts (2)
tabs (2)
5U106ebk3.book Page 6 Tuesday, April 15, 2003 1:22 PM
