Dell PowerConnect 7000 Series, Reference Manual

Page: 1254 / 1730

1254
Routing Information Protocol Commands
Example
The following example allows no RIP control packets to be sent by VLAN 11.
console(config-if-vlan11)#ip rip send version none
redistribute
The redistribute command configures RIP protocol to redistribute routes
from the specified source protocol/routers. If the source protocol is OSPF,
there are five possible match options.
Syntax
redistribute ospf
[
metric integer
] [
match
[
internal
] [
external 1
] [
external 2
]
[
nssa-external 1
] [
nssa-external 2
]]
no redistribute ospf
redistribute
{ static | connected } [ metric
integer
]
• metric
integer
— Specifies the metric to use when redistributing the route.
Range: 0-15.
• match internal — Adds internal matches to any match types presently
being redistributed.
• match external 1 — Adds routes imported into OSPF as Type-1 external
routes into any match types presently being redistributed.
• match external 2 — Adds routes imported into OSPF as Type-2 external
routes into any match types presently being redistributed.
• match nssa-external 1 — Adds routes imported into OSPF as NSSA Type-
1 external routes into any match types presently being redistributed.
• match nssa-external 2 — Adds routes imported into OSPF as NSSA Type-
2 external routes into any match types presently being redistributed.
• static — Redistributes static routes.
• connected — Redistributes directly-connected routes.
Default Configuration
metric
integer
— not configured
match — internal
2CSPC4.XCT-SWUM2XX1.book Page 1254 Monday, October 3, 2011 11:05 AM