Dell PowerConnect 6224, Command Line Interface Manual

Page: 1011 / 1372

Router Discovery Protocol Commands
1011
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
If a subnet includes any hosts that do not accept IP multicast packets, send
router advertisements to the limited broadcast address.
Example
The following example configures router discovery to send to the limited
broadcast address:
console(config)#interface vlan 15804 Router Discovery
Protocol Commands www. d e l l . c om | s u p p o r t
. d e l l .com console(config-if-vlan15)#no ip irdp
multicast
ip irdp preference
Use the ip irdp preference command in Interface Configuration mode to
configure the preference of the address as a default router address relative to
other router addresses on the same subnet. Use the no form of the command
to set the preference to the default value.
Syntax
ip irdp preference
integer
no ip irdp preference
•
integer
— Preference of the address as a default router address, relative to
other router addresses on the same subnet. (Range: -2147483648 to
2147483647
)
Default Configuration
0 is the default value.
Command Mode
Interface Configuration (VLAN) mode.