Dell PowerConnect 6224, Command Line Interface Manual

Page: 1101 / 1372

Clock Commands
1101
•
seconds —
Polling interval. (Range: 64-1024 seconds, in powers of 2)
Default Configuration
The polling interval is 64 seconds.
Command Mode
Global Configuration mode
User Guidelines
If a user enters a value which is not an exact power of two, the nearest power-
of-two value is applied.
Example
The following example sets the polling time for the Simple Network Time
Protocol (SNTP) client to 1024 seconds.
console(config)# sntp client poll timer 1024
sntp server
Use the sntp server command in Global Configuration mode to configure the
device to use Simple Network Time Protocol (SNTP) to request and accept
SNTP traffic from a specified server. To remove a server from the list of SNTP
servers, use the no form of this command.
Syntax
sntp server
{
ip-address
|
hostname
}
[
priority
priority
] [
poll
] [
key
key-
number
]
no sntp server ip-address
•
ip-address
— IP address of the server.
•
hostname —
Hostname of the server. (Range: 1-158 characters)
• poll — Enables polling.
•
key-number —
Authentication key to use when sending packets to this
peer.
(Range: 1-4294967295)