Removing the display assembly
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at
.
Prerequisites
1. Remove the
.
2. Remove the
.
Procedure
1. Remove the screw (M1.6x3) that secures the wireless antenna and camera-cable bracket to the system board.
2. Lift the wireless antenna and camera-cable bracket from the system board.
3. Disconnect and lift the camera-cable from the system board, peeling off the tape securing the camera-cable to the fans.
4. Remove the two screws (M1.6x2.5) that secure the display-cable bracket to the system board.
5. Lift the display-cable bracket from the system board.
6. Disconnect the display cable from the system board.
7. Disconnect the antenna cables from the system board.
8. Remove the four screws (M2.5x4) securing the display hinges to the palm-rest assembly.
19
Removing the display assembly
39
Summary of Contents for P82G
