Installing the status-light board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the status-light board and provides a visual representation of the installation procedure.
Steps
1. Place the status-light board into its slot on the palm-rest and keyboard assembly.
NOTE:
Ensure that the right side of the status-light board is aligned with the peg on the palm-rest and keyboard
assembly.
2. Connect the status-light board cable to the keyboard-control daughterboard on the palm-rest and keyboard assembly and
close the latch to secure the cable.
Next steps
1. Install the
.
2. Install the
.
After working inside your computer
.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
5. Remove the
Removing and installing components
41
