Figure 109. Installing the integrated storage controller card
Next steps
1.
.
2.
.
3. Follow the procedure listed in
After working inside your system
on page 28.
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type recommended by the manufacturer. For more information, see the safety
information that shipped with your system.
1. Follow the safety guidelines listed in
on page 27.
2. Follow the procedure listed in
Before working inside your system
3. If installed, disconnect the power or data cables from expansion card(s).
Steps
1. Locate the battery socket. For more information, see the
System board jumpers and connectors
section.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
2. Use a plastic scribe to pry out the system battery.
Figure 110. Removing the system battery
116
Installing and removing system components
Summary of Contents for Olympus O-T600
Page 21: ...Figure 16 Configuration and layout 20 Dell EMC PowerEdge T640 overview ...
Page 22: ...Figure 17 Electrical overview Dell EMC PowerEdge T640 overview 21 ...
Page 23: ...Figure 18 Memory information 22 Dell EMC PowerEdge T640 overview ...
Page 24: ...Figure 19 System tasks Dell EMC PowerEdge T640 overview 23 ...
