Dell Olympus O-T400, Installation And Service Manual, Page: 47 / 117

Figure 34. Installing a 2.5-inch drive into a 3.5-inch drive adapter
Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
Prerequisites
1. Follow the safety guidelines listed in Safety instructions .
2. If installed, remove the front bezel .
3. Remove the 3.5-inch drive carrier from the system .
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the rails on the drive carrier.
NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to remove the drive.
2. Lift the 3.5-inch drive adapter out of the 3.5-inch drive carrier.
46 Installing and removing system components