Dell Networking 2048, Reference Manual

Page: 147 / 1823

Command Groups
147
nsf helper strict-lsa-
checking
Set an OSPF helpful neighbor exit helper mode
whenever a topology change occurs.
ROSPF
nsf restart-interval Configures the length of the grace period on the
restarting router.
ROSPF
network area Enables OSPFv2 on an interface and sets its area
ID if the IP address of an interface is covered by
this network command.
ROSPF
passive-interface Sets the interface or tunnel as passive. IC
passive-interface default Enables the global passive mode by default for all
interfaces.
ROSPF
passive-interface Sets the interface or tunnel as passive. ROSPF
redistribute Configures OSPF protocol to allow redistribution
of routes from the specified source
protocol/routers.
ROSPF
router-id Sets a 4-digit dotted-decimal number uniquely
identifying the router OSPF ID.
ROSPF
router ospf Enters Router OSPF mode. GC
show ip ospf Displays information relevant to the OSPF
router.
PE
show ip ospf abr Displays the internal OSPF routing table entries
to Area Border Routers (ABR).
PE
show ip ospf area Displays information about the identified OSPF
area.
PE
show ip ospf asbr Displays the internal OSPF routing table entries
to Autonomous System Boundary Routes
(ASBR).
PE
show ip ospf database Displays information about the link state
database when OSPF is enabled.
PE
show ip ospf database
database-summary
Displays the number of each type of LSA in the
database for each area and for the router.
PE
show ip ospf interface Displays the information for the IFO object or
virtual interface tables.
PE
Command Description Mode
a
2CSNXXX_SWUM200.book Page 147 Tuesday, December 10, 2013 1:22 PM