Dell Networking 2048, Reference Manual

Page: 1741 / 1823

System Management Commands
1741
•
maxTtl
—
The largest TTL value that can be used (Range:1–255). The default is
30. This must be larger or equal to the value specified in initTtl.
•
maxFail
—
Terminate the traceroute after failing to receive a response for this
number of consecutive probes (Range: 0–255).
•
interval
—
The timeout period. If a response is not received within this period of
time, then traceroute considers that probe a failure (printing *) and sends the
next probe. If traceroute does receive a response to a probe, then it sends the
next probe immediately. (Range: 1–60 seconds). The default is 3.
•
count
—
The number of probes to be sent at each TTL level (Range:1–10).
•
port
—
The destination UDP port of the probe. This should be an unused port on
the remote destination system (Range: 1–65535).
•
size
—
The size, in bytes, of the payload of the Echo Requests sent (Range:
0–
39936
bytes). The default is 0.
•
src-ip-address
—
The IPv4 source address to use in the ICMP echo request
packets.
•
vlan
—
The source VLAN over which to send the echo request.
•
loop-id
—
A configured loopback ID
Default Configuration
The default count is 3 probes.
The default interval is 3 seconds.
The default size is 0 data bytes.
The default port is 33434.
The default initTtl is 1 hop.
The default maxTtl is 30 hops.
The default maxFail is 5 probes.
Command Mode
Privileged EXEC mode.
2CSNXXX_SWUM200.book Page 1741 Tuesday, December 10, 2013 1:22 PM