Steps
1. Remove the single (M2x2.5) screw from the WLAN bracket and lift it away from the system.
NOTE:
The fan cable is routed under the WLAN shield plate. It can only be accessed after the bracket is removed.
2. Disconnect the fan cable from the connector on the system board.
3. Remove the five (M2x2.5) screw from the heatsink assembly, then lift and remove the heatsink assembly from the system board.
Installing the heatsink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the heatsink assembly and provide a visual representation of the installation procedure.
38
Disassembly and reassembly
