Installing system board
1
Align the system board with the screw holders on the computer.
2
Replace the 6 (M2.0 x 3.0) screws to secure the system board to the computer.
3
Place the USB Type-C bracket on the Type-C module.
4
Replace the 2 (M 1.98 x 4L) screws to secure the USB Type-C bracket to the Type-C module.
5
Route the antenna cable through the routing clips and affix the tapes to secure the antenna cables.
6
Connect the power board and the speaker cable to the system board.
7
Affix the coin cell battery on the speaker cable.
8
Connect the USH board, Touchpad board and LED board cables to the system board.
1
NOTE:
If your computer has a WWAN card, then SIM card tray installation is a requirement.
9
Install the:
a
Connect the following cables from the system board
1
LED board cable
2
USH cable
3
Touchpad cable
b Connect the G-sensor and eDP cable
c Place the eDP bracket on the eDP cable and replace the 2 (M2 x 1.7L) screw on the bracket.
d Connect the IR camera and touch screen cables
e
f
g
h
i
j
k
NOTE:
To install both cards if equipped.
10 Connect the cables:
11 Follow the procedure in
After working inside your computer
.
Real time clock
Removing the Coin cell battery
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
NOTE:
SIM Card tray is available only if your computer is shipped with a WWAN card.
c
d
e
f
g
h
30
Removing and installing components
