Working on your tablet
Safety instructions
Prerequisites
Use the following safety guidelines to protect your tablet from potential damage and to ensure your personal safety. Unless otherwise
noted, each procedure in this document assumes that the following conditions exist:
•
You have read the safety information that shipped with your tablet.
•
A component can be replaced or, if purchased separately, installed by performing the removal procedure in reverse order.
About this task
NOTE:
Disconnect all power sources before opening the tablet. After you finish working inside your tablet, replace all
the components and screws before connection the power source.
WARNING:
Before working inside your tablet, read the safety information that shipped with your tablet. For more safety
practices information, see the
Regulatory Compliance Homepage
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching
an unpainted metal surface simultaneously as touching a connector on the back of the tablet.
CAUTION:
Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by
its edges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its pins.
CAUTION:
When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables
have connectors with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you
disconnect the cable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also,
before you connect a cable, ensure that both connectors are correctly oriented and aligned.
NOTE:
The color of your tablet and certain components may appear differently than shown in this document.
Before working inside your tablet
About this task
To avoid damaging your tablet, perform the following steps before you begin working inside the tablet:
Steps
.
2. Ensure that your work surface is flat and clean to prevent the tablet cover from being scratched.
3. Turn off your tablet.
4. If the tablet is connected to a docking device (docked) such as the mobile keyboard or a docking station, undock it.
5. Disconnect your tablet and all attached devices from their electrical outlets.
6. Press and hold the power button while the tablet is unplugged to ground the system board.
1
6
Working on your tablet
Summary of Contents for Latitude 7220
