Dell Latitude 12 7212, Owner'S Manual, Page: 15 / 79

8 Flip the display assembly by an angle less than 90°.
NOTE: Ensure not to flip more than 90° angle, as the display assembly ports and cables are connected to the system
board and may damage the display cables.
9 Before removing display assembly:
a Place the bottom edge of the display panel inside the bottom edge of the rear chassis.
b Flip open the display panel to 90° angle and lay it angled on the tablet chassis.
10 To disconnect the display cable:
a Remove the adhesive tape that secures the LVDS cable on the system board [1].
b Lift the latch with a plastic scribe on the system board.
c Disconnect the connector of LVDS cable from the slot by a plastic scribe [2] and remove the cable [3].
Removing and installing components 15