Removing the display assembly
WARNING:
Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at
Prerequisites
1
Remove the
2
Remove the
.
Procedure
1
Peel the tape that secures the touchscreen-board cable to the system board.
2
Open the latch and disconnect the touchscreen-board cable from the system board.
3
Peel the tape to release the touchscreen-board cable and remove the cable from the routing guides on the palm-rest assembly.
4
Peel the tape that secures the display cable to the system board.
5
Open the latch and disconnect the display cable from the system board.
6
Peel the tape that secures the display cable to the system board.
7
Remove the display cable from the routing guide on the palm-rest assembly.
8
Turn the computer over and open the display as far as possible.
CAUTION:
Place the computer on a soft and clean surface to avoid scratching the display.
9
Turn the computer over and remove the five screws (M2.5x3.5) that secure the display hinges to the I/O board and system board.
28
Removing the display assembly
45
Summary of Contents for Inspiron 7390 2n1
