Steps
1. Align the ports on the I/O board to the slots on the palm-rest and keyboard assembly.
2. Place the I/O board on the palm-rest and keyboard assembly.
3. Align the screw hole on the I/O board to the screw hole on the palm-rest and keyboard assembly.
4. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
5. Connect the I/O-board cable to the connector on the I/O board and close the latch.
6. Connect the power-button with fingerprint-reader cable to the connector on the I/O board and close the latch.
NOTE:
This step is only applicable to computers shipped with the optional fingerprint reader.
7. Connect the coin-cell battery cable to the I/O board.
8. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
9. Replace the two screws (M2.5x4) that secure the left-display hinge to the I/O board.
Next steps
1. Install the
.
After working inside your computer
.
Power-button
Removing the power-button
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
Removing and installing components
45
