Dell EqualLogic FS7600, Installation And Setup Manual

Page: 26 / 46

Steps for Connecting Network Cables
1. Obtain the correct number of network cables. For each controller, you need nine network cables, for a total
of 18 cables.
2. Connect the cables for the SAN/internal network connections.
3. Connect the cables for the client network connections. See Connecting the Client Network Cables on page
21 .
Figure 9 shows the recommended EqualLogic FS7600 network configuration. Table 8 describes the components
shown in the figure.
Figure 9: EqualLogic FS7600 Network Configuration
Table 8: Network Component Descriptions
Description Line Attributes
Switch stack for client connections Solid line (green)
Switch stack for SAN and internal network connections Dashed line (purple)
If you use VLANs within your switch stack, the SAN and internal networks must be in the same VLAN.
20
Dell EqualLogic FS7600 Installation and Setup Guide 4 Network Cable Connections