Steps
1. Using the Phillips 2 screwdriver, remove the screws that secure the right ear handle.
Figure 100. Removing the right ear handle for Rear Accessed configuration
2. Disconnect the power button control panel cable from the system board connector and remove the cable from cable clip.
NOTE:
Observe the routing of the cable as you remove it from the system.
3. Using the Torx 8 screwdriver, remove the screws that secure the right control panel assembly.
4. Hold the power button control panel assembly and remove the control panel along with the cable from the system.
NOTE:
Die Zahlen auf dem Bild zeigen nicht die genauen Schritte. Die Zahlen dienen der Darstellung der Sequenz.
Figure 101. Removing the power button control panel for Rear Accessed configuration
Next steps
Replace the power button control panel
.
102
Installieren und Entfernen von Systemkomponenten
