Installing the power button control panel for Rear Accessed
configuration
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in the
Before working inside your system
3.
.
4.
Remove the expansion card riser 1
.
Steps
1. Route the power button control panel cable through the side wall of the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the right control panel in the slot on the system.
3. Connect the power button control panel cable to the connector on the system board.
4. Using the Torx 8 screwdriver, tighten the screws that secure the right control panel to the system.
NOTE:
Die Zahlen auf dem Bild zeigen nicht die genauen Schritte. Die Zahlen dienen der Darstellung der Sequenz.
Figure 102. Installing the power button control panel for Rear Accessed configuration
5. Using the Phillips 2 screwdriver, tighten the screws that secure the right ear handle to the system.
NOTE:
Die Zahlen auf dem Bild zeigen nicht die genauen Schritte. Die Zahlen dienen der Darstellung der Sequenz.
Installieren und Entfernen von Systemkomponenten
103
