Figure 94. Installing the 2.5-inch rear drive cage
Next steps
1. Connect all the cables to the rear drive cage.
2.
.
4. Follow the procedure listed in
After working inside your system
.
Optional serial COM port
This is a service technician replaceable part only.
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
on page 25.
2. Follow the procedure listed in
Before working inside your system
3.
.
Steps
1.
(Riser 1, Riser 2a, Riser 2b, Riser 2c) and disconnect the serial COM port cable from the
connector on the system board.
2. Open the latch, slide the serial COM port out of the expansion card riser, and the lock the latch .
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components
95
