Related link
Removing a sled
Installing the expansion card riser assembly
Installing the expansion card riser assembly
Prerequisite
NOTE:
You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling
and airflow inside the system.
Follow the safety guidelines listed in
Steps
1
Place the expansion card assembly into the system board assembly.
2
Align the riser card connector with the connector on the system board, and press the expansion card riser assembly into place.
3
Using the Phillips #2 screwdriver, tighten the screws that secure the expansion card riser assembly.
Figure 42. Installing the expansion card riser assembly
Next steps
1
Install the sled into the enclosure.
2
Follow the procedure listed in
After working inside your system
.
Related link
Removing an expansion card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the sled from the enclosure.
4
Remove the expansion card riser assembly.
96
Installing and removing system components
Summary of Contents for EMC PowerEdge C6420
Page 1: ...Dell EMC PowerEdge C6420 Regulatory Model E43S Series Regulatory Type E43S001 ...
Page 8: ...Figure 1 Supported configurations for PowerEdge C6420 8 PowerEdge C6420 overview ...
Page 64: ...Figure 12 Removing a sled 64 Installing and removing system components ...
Page 66: ...Figure 14 Installing a sled 66 Installing and removing system components ...
