Next steps
Follow the procedure listed in
After working inside your system
.
Installing expansion card risers
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1.
If applicable, reinstall the expansion card(s) into the expansion card riser.
2.
Align the expansion-card riser with the connector and the riser guide pin on the system board.
3.
Lower the expansion-card riser into place until the expansion-card riser connector is fully seated in
the connector.
Next steps
1.
Follow the procedure listed in
After working inside your system
.
2.
Install any device drivers required for the card as described in the documentation for the card.
Internal dual SD module
The Internal Dual SD Module (IDSDM) card provides two SD card slots. This card offers the following
features:
• Dual card operation — maintains a mirrored configuration using SD cards in both slots and provides
redundancy.
NOTE: When the
Redundancy
option is set to
Mirror Mode
in the
Integrated Devices
screen of
System Setup, the information is replicated from one SD card to another.
• Single card operation — single card operation is supported, but without redundancy.
Removing the internal dual SD module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
.
2.
Follow the procedure listed in
Before working inside your system
Steps
1.
Locate the internal dual SD module on the system board.
2.
If installed, remove the SD card(s).
3.
Hold the plastic pull tab and pull the dual SD module out of the system board.
67
