5
remote management port card connector on the system
board
Next steps
1
Install the expansion card riser.
2
If applicable, connect the required power or data cables to the expansion card(s).
3
Install the cooling shroud.
4
If applicable, open the expansion card latch on the cooling shroud to support the full length expansion card.
5
Follow the procedure listed in the After working inside your system section.
Related links
Before working inside your system
Removing the cooling shroud
Installing the optional remote management port card
Installing the cooling shroud
After working inside your system
Safety instructions
Installing the optional remote management port card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your system section.
3
Remove the cooling shroud.
NOTE:
If applicable, close the expansion card latch on the cooling shroud to release the full length card.
4
If applicable, disconnect the cables from expansion card(s).
5
If applicable, remove the expansion card riser.
Steps
1
Align and insert the tabs on the remote management port card on the slots on the chassis wall.
2
Insert the remote management port card into the connector on the system board.
3
Tighten the screws to secure the remote management port card.
Installing and removing system components
109
