Removing the optional remote management port card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your system section.
3
If applicable, disconnect the cables from expansion card(s).
4
Remove the expansion card riser.
NOTE:
If applicable, close the expansion card latch on the cooling shroud to release the full length card.
5
Remove the cooling shroud.
6
Keep the Phillips #2 screwdriver ready.
Steps
1
Disconnect the management network cable from the remote management port.
2
Loosen the two screws securing the remote management port card holder to the system board.
3
Pull the remote management port card up and toward the front of the system to disengage it from the connector and remove the card
from the chassis.
Figure 51. Removing the optional remote management port card
1
remote management port card holder
2
remote management port
3
remote management port card
4
screw (2)
108
Installing and removing system components
