8.
Align the notch on the bottom of the module with the crossbar in the connector.
9.
Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
10.
Close the computer cover
.
11.
Attach the computer stand
(optional).
12.
Connect your computer and devices to electrical outlets, and turn them on.
13.
Right-click the
My Computer
icon and click
Properties
.
14.
Click the
General
tab.
15.
To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Removing Memory
1.
Shut down the computer
through the
Start
menu.
2.
Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut
NOTICE:
To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of the
module.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Owner's Manual
or
Product Information
Guide
.
NOTE:
Memory purchased from Dell is covered under your computer warranty.
Summary of Contents for Dimension 4600C
Page 5: ...Back to Contents Page ...
Page 13: ...Back to Contents Page ...
Page 34: ...Back to Contents Page ...
