Steps
1. Align the notch on the SSD with the tab on the solid-state drive connector on the Dell Ultra Speed Drive.
2. Install the standoff nut on the notch of the SSD.
3. Replace the single screw (M2x5) securing the standoff nut to the Dell Ultra Speed Drive.
4. Flip over the Dell Ultra Speed Drive with the SSD facing up.
5. Replace the Dell Ultra Speed Drive into the slot on the riser card until it clicks into place.
6. Close the expansion card latch and press it until it clicks into place.
Next steps
1. Install the
.
2. Install the
NOTE:
This step is valid for system configuration that is shipped with 80 W CPU.
3. Install the
4. Install the
5. Install the
.
6. Follow the procedure in
after working inside your computer
.
Grafische kaart
Removing the graphics card
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
3. Remove the
4. Remove the
.
5. Remove the
.
NOTE:
This step is valid for system configuration that is shipped with 80 W CPU.
6. Remove the
About this task
The following images indicate the location of the graphics card and provide a visual representation of the removal procedure.
Demonteren en hermonteren
53
Summary of Contents for D16S
