Replacing the processor-cooling assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
Before working inside your computer
. After working inside your computer, follow the instructions
After working inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
Procedure
1
Slide the radiator and fan assembly into the radiator and fan cage.
2 Align the screw holes on the processor cooler with the screw holes on the system board.
3 In sequential order (indicated on the processor cooler), tighten the four captive screws that secure the processor cooler to
the system board.
NOTE: If your are using an electric screwdriver, torque the screws at 6.9 +/-1.15 kilogram-force centimeter (6
+/-1 pound force inch).
4 Connect the processor-cooling assembly cables to the system board.
5 Align the screw holes on the VR heat sink with the screw holes on the system board.
55
Summary of Contents for Alienware Aurora R8
