Dell Alienware 13 R3, Service Manual

Page: 59 / 78

Replacing the camera cable
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your computer . After working inside your computer, follow the instructions in After working inside your
computer . For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance .
Topics:
• Procedure
• Post-requisites
Procedure
1. Route the camera cable through the routing guides on the display back-cover and antenna assembly.
2. Connect the camera cable to the camera module.
Post-requisites
1. Replace the display hinges .
2. Replace the display panel .
3. Replace the display bezel .
4. Replace the display assembly .
5. Replace the system board .
6. Replace the battery .
7. Replace the heat-sink assembly .
8. Replace the coin-cell battery .
9. Replace the computer base .
10. Replace the rear-I/O cover .
11. Replace the memory modules .
12. Replace the solid-state drive .
13. Replace the wireless card .
14. Replace the base cover .
59