Dell Alienware 13 R3, Service Manual

Page: 56 / 78

Replacing the display bezel
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your computer . After working inside your computer, follow the instructions in After working inside your
computer . For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance .
Topics:
• Procedure
• Post-requisites
Procedure
1. Place the display assembly on a clean and flat surface.
2. Connect the logo-board cable to the logo board.
3. Adhere the tape that secures the logo-board cable to the logo board.
4. Slide the alien head logo-board cable into the logo board and close the latch to secure the cable.
5. Carefully turn the display bezel over.
6. Align the display bezel with the display back-cover and antenna assembly and gently snap the display bezel into place.
Post-requisites
1. Replace the display assembly .
2. Replace the system board .
3. Replace the heat-sink assembly .
4. Replace the battery .
5. Replace the coin-cell battery .
6. Replace the computer base .
7. Replace the rear-I/O cover .
8. Replace the memory modules .
9. Replace the solid-state drive .
10. Replace the wireless card .
11. Replace the base cover .
56