Dell Alienware 13 R3, Service Manual

Page: 50 / 78

Replacing the display assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in
Before working inside your computer . After working inside your computer, follow the instructions in After working inside your
computer . For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance .
Topics:
• Procedure
• Post-requisites
Procedure
1. Route the cables through the routing holes on the palm-rest assembly.
2. Align the screw holes on the display hinges with the screw holes on the palm-rest assembly.
3. Replace the four screws (M2.5x6L) that secure the display assembly to the palm-rest assembly.
4. Turn the computer over.
5. Route the display cable through the routing guides on the palm-rest assembly.
6. Route the logo-board cable through the routing guides on the palm-rest assembly.
7. Route the antenna cables through the routing guides on the palm-rest assembly.
Post-requisites
1. Replace the system board .
2. Replace the battery .
3. Replace the heat-sink assembly .
4. Replace the coin-cell battery .
5. Replace the computer base .
6. Replace the rear-I/O cover .
7. Replace the memory modules .
8. Replace the solid-state drive .
9. Replace the wireless card .
10. Replace the base cover .
50