Steps
1. Connect the touch cable to its connector on the touch screen board.
2. Connect the eDP cable to its connector on the LCD module and flip the display bezel on the display assembly.
3. Align the display bezel with the display assembly. Gently snap the display bezel into place.
4. In sequential order, replace the 11 (M2.5x6, T8) screws that secure the display bezel to the display assembly.
NOTE:
Ensure that the display assembly is placed on a flat surface when replacing the screws to avoid light leakage
from LCD. This must be done when part twisting assembly screw torque: 3 kgf-cm.
5. Replace the 4 (M2.5x6, T8) epoxy screws to secure the display bezel to the display assembly.
Next steps
1. Install the
.
2. Install the
.
3. Install the
.
4. Install the
.
5. Install the
6. Install the
.
7. Install the
.
8. Install the
.
9. Install the
.
10. Install the
.
11. Install the
.
12. Install the
13. Install the
.
14. Install the
.
15. Install the
.
16. Install the
.
17. Install the
primary M.2 2280 solid state drive
primary M.2 2230 solid state drive
.
18. Install the
.
after working inside your computer
.
90
Removing and installing components
Summary of Contents for 7330
