Back to Contents Page
Display Assembly and Display Latch
Dell™ Latitude™ D510 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Latch
Display Assembly
1.
Follow the instructions in "
Preparing to Work Inside Your Computer
."
2.
Remove the
keyboard
.
3.
Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.
4.
Remove the captive screw that grounds the display cable.
5.
Disconnect the display cable from the display cable connector on the system board.
6.
Release the display cable from its routing clips and slide it out from beneath the tab on the palm rest.
7.
Release the two antenna cables from the two antenna-securing clips.
8.
Disconnect one antenna cable from the display by holding the two gold antenna connectors and gently pulling them apart. Then disconnect the other
antenna cable. (The gold antenna connectors on each cable are keyed to ensure that they are correctly reconnected.)
CAUTION:
Before performing the following procedures, read the safety instructions in your
Product Information Guide
.
NOTICE:
To prevent damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's
electronic components. You can do so by touching an unpainted metal surface.
NOTICE:
You must remove the display assembly before you remove the palm rest.
1 captive screw
2 display cable
