Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
key: 15.9 mm width x 57.15 mm length x 7.9 mm height.
1
Follow the safety guidelines listed in the
.
2
Follow the procedure listed in the
Before working inside your system
3
Remove the expansion card riser
Steps
1
Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
System board jumpers and connectors
section.
2
If installed, remove the USB memory key from the USB port.
3
Insert the replacement USB memory key into the USB port.
Next steps
1
Replace the expansion card riser
.
2
Follow the procedure that is listed in
After working inside your system
.
3
While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Optional optical drive
Removing the optional optical drive
Prerequisites
1
Follow the safety guidelines listed in the
2
Follow the procedure listed in the
Before working inside your system
3
.
4
.
5
Disconnect the cables from the connectors on the optical drive.
NOTE:
Ensure that you note the routing of the power and data cable on the side of the system as you remove them from
the system board and drive.
Steps
1
Press the release tab to release the optical drive from the system.
2
Slide the optical drive out of the system until it is free of the optical drive slot.
3
If you are not installing a new optical drive, install the optical drive blank.
NOTE:
The procedure to install an optical blank is similar to the optical drive.
Installing and removing system components
79
