Card type
Slot priority
Maximum number of cards supported
CRD, NTWK, PCIE, QP, 1G, BCOM, LP, V2
1
1
CRD, NTWK, PCIE, 1GB, QP, INTEL, V3
2
1
CRD, NTWK, PCIE, 1GB, QP, INT, LP, V3
1
1
CRD, NTWK, DP, BCOM, 1G
2
1
CRD, NTWK, DP, BCOM, 1G, LP
1
1
CRD, NTWK, PCIE, 1GB, DP, INTEL, V3
2
1
CRD, NTWK, PCIE, 1GB, DP, INT, LP, V3
1
1
Removing the expansion card riser
Prerequisites
1
Follow the safety guidelines listed in the
.
2
Follow the procedure listed in the
Before working inside your system
3
.
Steps
1
Open the blue expansion card riser retention-latch located on the system.
2
Holding the blue touch points, lift the expansion card riser out of the system.
Figure 39. Removing the expansion card riser
3
If you are not replacing the expansion card riser, install a expansion card riser filler bracket by performing the following steps:
a Align the expansion card riser filler bracket with the slot on the system.
b Push the expansion card riser filler bracket downward until firmly seated.
c Close the blue expansion card retention latch by pushing the latch down until the latch snaps into place.
d Using a Phillips #2 screwdriver, tighten the screw to secure the expansion card riser filler to the chassis.
Installing and removing system components
69
