Figure 48. Removing the optional IDSDM module
Next step
.
Installing the optional internal dual SD module
Prerequisites
Follow the safety guidelines listed in
NOTE:
You must install either the Internal dual SD module (IDSDM) or the BOSS M.2 card in the same IDSDM/BOSS M.2
connector.
NOTE:
The procedure to install IDSDM and the BOSS M.2 card is the same.
Steps
1
Holding both ends of the IDSDM, insert the IDSDM into the IDSDM/BOSS M.2 connector on the system board.
NOTE:
For information on the location of the IDSDM/BOSS M.2 connector, see the System board jumpers and connectors
section.
2
Push the release tab that secures the IDSDM to the system board, in place.
3
Using the Phillips #2 screwdriver, tighten the retention screw that connects the internal dual SD module (IDSDM) to the system board.
4
Pressing the release latches, lower the drive backplane into the system until it is firmly seated, and the latches engage with the
system.
92
Installing and removing system components
