Table 7. Rear view of the system (continued)
Item
Ports, panels, or slots
Icon
Description
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
●
To reset iDRAC using system ID, ensure that the
system ID button is enabled in the iDRAC setup.
●
If the system stops responding during POST, press
and hold the system ID button (for more than 5
seconds) to enter the BIOS progress mode.
11
OCP NIC port (optional)
N/A
This port supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
12
NIC port (2)
The NIC ports are embedded on the LOM card that is
connected to the system board.
13
BOSS S2 card (optional)
N/A
This slot supports the BOSS S2 module
For more information about the ports, see the
section.
Figure 9. Rear view of the 4 x 3.5-inch drive system with 2 x 2.5-inch rear drive module
Table 8. Rear view of the system
Item
Ports, panels, or slots
Icon
Description
1
Power supply unit (PSU 1)
For more information about the PSU configurations, see the
section.
2
Rear drive module
N/A
Enables you to install drives that are supported on your
system. For more information about drives, see the
section.
3
USB 2.0 port (1)
This port is USB 2.0-compliant.
4
PCIe expansion card riser
(slot 3)
N/A
The expansion card riser enables you to connect PCI
Express expansion cards. For more information about the
expansion cards that are supported on your system, see
section.
5
Power supply unit (PSU
2)
For more information about the PSU configurations, see the
section.
6
VGA port
Enables you to connect a display device to the system. For
more information, see the
7
USB 3.0 port (1)
This port is USB 3.0-compliant.
8
iDRAC dedicated port
Enables you to remotely access iDRAC. For more
information, see the iDRAC User’s Guide at
System overview
15
