Figure 114. Removing the intrusion switch module
Next steps
1.
Replace the intrusion switch module
.
Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
on page 25.
2. Follow the procedure listed in
Before working inside your system
3.
Remove the expansion card riser
.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Align the guides on the intrusion switch module with the standoffs on the system.
2. Slide the intrusion switch module into the slot in the system until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the screw on the intrusion switch module.
4. Connect the intrusion switch cable to the connector on the rear I/O board.
Installing and removing system components
113
